What you need
7-8″ large link sterling chain
1 large lobster clasp
1 100pc package of 1 1/2″ thin headpins
Assorted beads: 200-300, including spacers
Step 2 – Add 1/2″ of beads to headpin.
Step 3 – Grip headpin wire with the tip of the chain-nose plier just above the beads and bend to a 90ý angle.
Step 4 – Using the round-nose pliers turn the wire up and around to form a loop, bringing the wire back to a right angle.
Step 5 – Slip the loop into the link of the chain.
Step 6 – Using the chain-nose plier, hold loop and wrap the wire several times around until it reaches the base of the bead. Remember to keep the wire at a right angle while wrapping. This will ensure an even coil.
Step 7 – Trim excess wire, and tuck the end down with the chain-nose plier. This can be tricky – use the tip of the plier on the tip of the wire and gently press into the direction of the coil.
Step 8 – Repeat the process until desired fullness is achieved. Usually 2 dangles from each chain link.
This project was contributed by Beadstudio.com Visit their website for beading supplies, projects, classes and articles