Recycled Skittles Pouch

Recycled Skittles Pouch

This little project was inspired by my son who asks for candy from the brightly colored packages at the checkout at Target. So, here's a little "sweet tooth" pouch.

What you need

iron-on vinyl
a zipper (7 – 9″ works well)
two pieces of fabric for lining (each should be the size of your candy wrapper).

thread, sewing machine, zipper foot, iron, X-acto knife

Instructions

We don’t normally have a lot of candy in the house.  Well, the Halloween candy (at least nothing with chocolate – because that’s all eaten within hours) is still in a jar in the kitchen cupboard.

You’ll need two candy pouches – I used Skittles and M&Ms.  You could use candy bars too (you just might need more than one per side to make it a bit bigger).

Open Skittle Bag

First, we’ll put the vinyl onto our candy wrappers.  Carefully remove the back of the candy wrapper leaving the top piece fully intact.

Cut two pieces of vinyl slightly larger than the wrapper.  Peel off the paper backing and stick to the front of the wrapper, smoothing out with your fingers.

Cut Vinyl Pieces

Using a clean rag (or ironing cloth), iron the vinyl for 8-10 seconds on medium heat.  Repeat for the other side.  Trim any excess vinyl.  Repeat for the other wrapper.

Iron with rug

Ironed On

Now that you have your wrappers covered in vinyl, we’ll assemble the pouch.

Assemble Lining

Place your lining fabric right side up and then place the zipper on top matching the edges.  Zipper should be facing up, as in the photo.

Add Zipper

Place the wrapper on top (right side down).

Increase your stitch length and using a zipper foot, sew along the length of the zipper.

Sew along zipper length

Fold over the front and lining (so wrong sides are now touching) and add the other piece of lining and wrapper to the other side of the zipper.

Now the top looks like this:

What the top looks like

and the other side looks like this:

What the bottom looks like

Now fold the bag so the the lining is touching and the wrappers are touching (right sides together) like this:

Fold the bags

Starting with the lining, sew around the bag.

Make sure you pull the zipper partway open so you can turn it inside out later.

When you get to a zipper, make sure it’s “pushed” toward the lining.

Push Lining

Continue around the bag, leaving a large opening at the bottom for turning.  A large opening is best (even larger than pictured below).  The vinyl wrapper is a bit stiff and difficult to fit through a small opening.

LEave Opening for pouch

Trim the extra zipper bits and trim the corners (turning points)

Carefully turn the bag right side out.  Sew up the bottom of the lining (by hand or machine) and tuck it into the pouch.

Don’t forget to have your little one fill it with treasures – a favorite car, a new library card and of course, a frog.

Finished Skittles Pouch

This project was contributed with permission from Vanessa http://punkinpattern.blogspot.com

Comments

  1. Awessssuuuuummm! 😀

  2. I use sticky clear shelf liner instead of iron on less steps. thanks this is a great project.

  3. I like the easy to follow instruction and illustrated pictures. I am thinking of teaching this to my students. Will let you know how it goes! Thx a lot.

  4. Oh so cute!

  5. where can i get iron on vinyl??

  6. Love this project and just in time for school I’ll whip up a couple for my kids pencil holders. Thanks for this idea!

  7. adorable!

  8. good idea

  9. This project is looks great and easy instructions to follow deffinately going to try this thanks for the great idea 🙂

  10. love the pictures-definetly making 🙂 thanks for the fabulous project!

  11. Ahh LOVE IT!! (: I love me some skittles, too (;

  12. I can’t wait to do this! My nieces and nephews will LOVE it!

  13. pretty creative!

  14. Very cute!

  15. Excellent instructions! This is a great project. Thank you for sharing!

Leave a Reply to GuestCancel reply