What you need
1 pink-purple 25mm photobead with asters and chrysanthemums
1 crystal heart charm
270 black seed beads
270 mixed red, dark red and pink seed beads
120 small garnet nuggets
3 coils of necklace memory wire 40cm (16″) each
4 silver plated 6mm jump rings
2 silver plated 4mm jump ring
1 round part of a silver plated 13mm toggle clasp (you will not need the t-bar for this project)
1 silver plated lobster clasp
1 silver plated eye pin
TOOLS:
Round nose pliers
Flat nose pliers
Wire cutters
FINISHED SIZE: 39cm
(15″)
Instructions
1. Make a loop on one end of a necklace memory wire coil. String all black seeds and make loop to finish off the coil. Repeat this with a coil of garnet stones and a coil of red and pink seed beads.
2. Put the coils together and connect the three loops of one side together using a 6 mm jump ring. Use another 6 mm jump ring to attach the lobster clasp to the choker. Slightly twist the coils and connect the loops of the other side using another 6 mm jump ring. Attach another 6 mm jump ring.
3. Attach the crystal heart charm to the eye of the eye pin using one 4 mm jump ring. String the photobead on the eye pin. Using your round nose pliers make a loop attaching the bead to the round part of a toggle clasp.
4. Slide the heart pendant onto the choker.
This project was submitted by Photobeads
i think that the materials needed should be waaaaaay less specific then they are. People dont want to go out and buy special beads for one project.
Cute! U gottza luv it.